new to lazer etch
- Tesral
- Administrator
- Posts: 4937
- Joined: Tue Dec 18, 2012 12:58 pm
- Location: Dearborn, Mi -- at my desk.
- Contact:
Re: new to lazer etch
Like, Ditto. While I'm a long time modeler this is a place I haven't been. Even the oldest dogs if you will.
Garry AKA --Phoenix-- Rising above the Flames.
"I saw it done on Voyager" is no excuse for anything, even breathing.
"I saw it done on Voyager" is no excuse for anything, even breathing.
- Moongrim
- Fatidical Fleet Admiral
- Posts: 4962
- Joined: Tue Mar 12, 2013 9:36 pm
- Location: West of Eugene Oregon.
Re: new to lazer etch
Lazer etching sounds intriguing.
But mine eyes are bigger than my tummy- so to speak. Grandiose plans for same- has yet to meet up with reality.
But mine eyes are bigger than my tummy- so to speak. Grandiose plans for same- has yet to meet up with reality.
There are Times, Sir, when men of good Conscience cannot blindly follow orders. You acknowledge their sentience, but ignore their personal liberties and freedoms. Order a man to hand over his child to the state? Not while I"m captain.
- J.L.Picard.
- J.L.Picard.
- trekriffic
- Admiral of the Fleet
- Posts: 2742
- Joined: Mon Oct 01, 2012 4:16 pm
Re: new to lazer etch
Haven't had much experience with lazer etch or where to find it. All of my builds have used brass photo-etch.
"You broke your little ships."
My albums on flickr: https://www.flickr.com/photos/29607470@N08/sets/
My albums on flickr: https://www.flickr.com/photos/29607470@N08/sets/
- MEATLOAFr
- Velutinous Vice Admiral
- Posts: 2624
- Joined: Fri Sep 28, 2012 12:46 pm
- Location: Omaha, NE
Re: new to lazer etch
There's a home version now available for pre-ordering
https://glowforge.com/
cheapest version is $2395 US
https://glowforge.com/
cheapest version is $2395 US
If the world ends tomorrow, it's ALL YOUR FAULT!!!
Custom Decals, and Vinyl Cutting services available
ABLE TO PRINT DECALS IN WHITE
NOW ABLE TO 3D PRINT SMALL SCALE MODELS (ANYCUBIC PHOTON & MONO X) have STL, will print!!
Custom Decals, and Vinyl Cutting services available
ABLE TO PRINT DECALS IN WHITE
NOW ABLE TO 3D PRINT SMALL SCALE MODELS (ANYCUBIC PHOTON & MONO X) have STL, will print!!
- tmlindsey
- Charismatic Commander
- Posts: 306
- Joined: Tue May 21, 2013 12:22 am
- Location: Between the ticks and tocks of Time
- Contact:
Re: new to lazer etch
Glowforge; ugh.kobayashimaru wrote: ↑Mon Jan 18, 2016 10:16 pm the local co-op is looking to acquire a glowforge lite
Why is that? If you don't mind me asking.kobayashimaru wrote: ↑Mon Jan 18, 2016 10:16 pm ...in the meantime, we just rent lazer-engraver time from a local builder,
but we're limited to the complexity and number of cuts
Tim L.
https://www.tmlindsey.com
https://www.tmlindsey.com