RM Contender WIP

[mophius]

New sheet of letters and numbers printed off tonight. I will be glosscoating the sheet tomorrow at work. Hopefully tomorrow evening or Sunday evening I will be able to apply them correctly.

Is it worth me sharing the sheet on the Cadet series thread so that others may benefit or will that tread on some toes

[MEATLOAFr]

Is it worth me sharing the sheet on the Cadet series thread so that others may benefit or will that tread on some toes

that's fine, more resources for everyone

[mophius]

Well I was going to but the file size is too large. I didn't realise that it was 5.9mb

[MEATLOAFr]

Well I was going to but the file size is too large. I didn't realise that it was 5.9mb

don't feel bad - my "straight window" file is over 27MB

[mophius]

The sheet size is just under 6" x 4" so thought it would be safe. Never mind.
I did just straight black lettering in Millennium font. I didn't work out how to get the red edging on there until after I printed two sheets and then time was getting on. Daughter was already in bed and the printer is noisy.
Hopefully they look ok.

Even this pic is 2.9mb

[Vahmp]

Well I was going to but the file size is too large. I didn't realise that it was 5.9mb

Hey Mophius,
Think I could get a copy?
If so, here's my addy: lord_vahmp@yahoo.com

[mophius]

Well I was going to but the file size is too large. I didn't realise that it was 5.9mb

Hey Mophius,
Think I could get a copy?
If so, here's my addy: lord_vahmp@yahoo.com

You sure can, I'll send it straight after I post this.

Small update as to the registry decals. I should have put a space between the last 'C' and the '-'. I also need to trim one of the C's as it has a shaving off of another C. I trimmed the letters of the registry apart as I soaked them and placed them around the saucer at the same time I put the numbers on. I used the lines of the suacer to place.

fitted the nacelles on permanently now so next stage will be a test.

Just need a gloss and dullcoat now.

In review of the post, I should have used smaller numbers on the ventral surface. Live and learn.

[Vahmp]

Well I was going to but the file size is too large. I didn't realise that it was 5.9mb

Hey Mophius,
Think I could get a copy?
If so, here's my addy: lord_vahmp@yahoo.com

You sure can, I'll send it straight after I post this.

Thank you!
And great job on the ship.

[dJiPi]

I’d like to see an up-to-date re-cast of this model, maybe from a new 3D print master ?
And with separate wrap nacelles so we can upgrade/refit it easily

[Resin-Modeller]

hint taken lol